Trace both sides of an isolated logic-level UART, check the ground paths introduced by debug equipment, and isolate startup and return-channel faults.
Digital Isolator Default Output States and Power-Loss Behavior
Check digital isolator default outputs, input-side and output-side power loss, logic polarity, startup behavior, and pull-resistor limits before selection.
Digital Isolator CMTI: What It Means for Signal Reliability
Understand digital isolator CMTI, calculate dv/dt, read test conditions, and separate signal immunity from isolation voltage when reviewing a device.
Choosing an Optocoupler for a 24 V Industrial Digital Input
Choose an optocoupler for a 24 V digital input using LED current, resistor power, logic thresholds, timing and isolation requirements.
How to Test an Optocoupler with a Multimeter
Test a phototransistor optocoupler with diode mode and a low-voltage output check. Interpret readings without confusing basic response with full qualification.
Optocoupler Turn-Off Delay: Diagnose Pull-Up, Capacitance and Saturation
Diagnose optocoupler turn-off delay with waveform clues, controlled load tests and an RC estimator. Separate node charging from continued conduction.
How to Read Optocoupler CTR Curves: Current, Temperature and Design Margin
Read optocoupler CTR curves, match current and temperature conditions, calculate load requirements, and distinguish estimates from guaranteed limits.
Switching Power Supply Circuit Explained: Blocks, Control and Protection
Understand a switching power supply circuit from AC input to DC output. Compare flyback and forward stages, feedback, PFC and component protection.
PCB Layout for EMC: A Practical EMI Troubleshooting Guide
Find PCB EMI sources, fix buck hot loops and return paths, select filters under real operating conditions, and verify the complete product.
UART Communication: Wiring, Baud Rate and Reliable Links
UART communication sends serial data without a shared clock wire. A Universal Asynchronous Receiver/Transmitter converts bytes into timed frames and reconstructs received frames as data. A working link also needs









